Attaches to the WaterRower seat, between the load wheels and seat sides, helping to prevent clothing or other items from becoming trapped in the load wheels.
Compatible with WaterRower Original, Metallic and Lite models.
Replacement load wheel assembly for securing the seat load wheel to the seat axle and allowing the seat to travel smoothly along the rails.
Compatible with: WaterRower Original, Metallic, S1 and Lite models.
Includes: One load wheel with bearings, two washers, one wave washer and one circlip.
Please note: Four load wheel assemblies are required per WaterRower. These wheels sit on the sides of the seat and should not be confused with the guide wheels, which sit at a 90-degree angle and keep the seat aligned on the rail extrusions.
Replacement guide wheels that sit underneath the seat, keeping it securely aligned with the rails as it moves.
Compatible with: WaterRower wooden and S1 models. Two versions are available:
WRP-S405: 3 cm diameter guide wheels for current models.
WRP-S400: 3.5 cm diameter guide wheels typically used on models over 25 years old.
Includes: Four guide wheels, four spacers and four washers.
Please note: Measure the diameter of your existing guide wheels before selecting a variant. If you are unsure which version is compatible with your WaterRower, please contact our team.
Circlip set used to secure the load wheels to the seat axles.
Compatible with WaterRower Original, Metallic and Lite models.
This is an updated E-clip design. Older WaterRower models were fitted with C-clips, which required circlip pliers to install. This updated version is compatible with seats previously fitted with C-clips and can be installed without circlip pliers.
